Enhanced Power 6L Ultrasonic Cleaner 150W 300W Heating Illuminated Timer

The GT SONIC-T6 is where the T series becomes a batch tool. The 300 x 150 x 150 mm tank holds six litres, enough for a rack of test tubes, a tray of dental instruments, a set of carburettor bodies, pump components, small gearbox parts or a stack of PCB panels. 150 W of ultrasonic power at 40 kHz is distributed across the floor so a full basket cleans in one pass, and the 300 W heater brings six litres to working temperature far faster than the smaller elements in the series. Two stage switching, illuminated knobs, constant temperature sensing and the leak proof tank construction carry over unchanged, which keeps operation familiar as a workshop grows from a T2 to a T6.

• Six litre batch tank: A 300 x 150 x 150 mm cavity takes racks, trays and baskets rather than single parts, so a day of preparation can be run in a few loads.
• 300 W heating element: The larger heater matches the larger bath, reaching the 20 to 80 degrees Celsius window quickly and recovering after cold baskets go in.
• Two stage power control: Full power handles carbon, scale and burnt oil; the lower stage protects aluminium, plated finishes and thin sheet parts without changing the solution.
• Illuminated rotary knobs: Timer up to 30 minutes and thermostat are adjusted through 360 degree illuminated knobs that stay legible under bench lighting or in a dim shop.
• Constant temperature sensing: The heater cycles against a temperature sensor, so the bath holds its set point instead of overshooting and cooking temperature sensitive parts.
• Leak proof construction: SUS304 tank, new seam process and full leak testing on every unit keep liquid away from the generator bay and extend service life under daily use.

The T6 serves workshops and laboratories that clean in batches. Carburettor and injector specialists clean throttle bodies, jets, needles and small housings; machine shops process taps, reamers, collets and small gear sets; electronics production cleans stencil wipes, connectors and small boards. Dental and veterinary clinics run trays of instruments, optical workshops clean lens barrels and mounts, and jewellery benches process trays of rings and chains after polishing. Laboratories use it for tube racks, sieve stacks and beaker batches before analysis.

The T series is covered by CE verification (T188066801 and T188066802), RoHS compliance (T188066803), FCC verification (T188103901 and T188103902) and REACH compliance (T188085501). Report copies are supplied with the shipping documents for customs clearance, tender submission and distributor registration, and the design is patent protected, so a repeat order matches the tested sample rather than drifting between production runs.

The machine ships in a moulded foam gift box inside a master carton with basket, lid, cord and manual, and cartons can be palletised for container loading. Testing covers a loaded two hour run, heater ramp, tank leak, knob and light column check, with the inspection sheet tied to the serial number. The one year warranty covers generator, transducers and heater, and consumables such as baskets, lids and fuses are kept in stock.

Send the basket or rack dimensions you plan to immerse and the number of cycles per day, and we will confirm the six litre tank or quote the T9 for heavier loads.