Power Boost 2L Ultrasonic Cleaner 50W Dual Stage Heating 40kHz Cleaning Unit

The GT SONIC-T2 is the smallest machine in the T series, a two litre bench unit that takes the same chassis as the smart S2 but swaps the touch panel for a pair of illuminated rotary knobs and adds a two stage power switch. The 150 x 135 x 100 mm tank is sized for optical ferrules, dental burs, jewellery settings, small nozzles, circuit board offcuts and lab glassware, and 40 kHz cavitation lifts polishing paste, cutting oil and oxidised film out of slots and blind holes that a brush cannot reach. The heater runs from 20 to 80 degrees Celsius with constant temperature sensing, so a warm detergent bath stays inside its working window instead of cycling hot and cold. Two power levels let an operator clean tough parts at full amplitude and switch down for plated or thin walled items without changing the bath.

• Two stage ultrasonic power: A front switch steps the output between the two levels the T series is built around, so heavy carbon removal and delicate cleaning share one machine and one tank of solution.
• Illuminated light column knobs: Timer and temperature are set on 360 degree illuminated knobs, which stay readable in a dim workshop and can be turned with a wet glove on the hand.
• Constant temperature heating: The 100 W heater works with temperature sensing to hold the bath between 20 and 80 degrees Celsius, improving removal of oils and waxes without overheating delicate parts.
• Leak proof tank construction: A new seam process and full weld inspection on the SUS304 tank reduce the risk of seepage at the base, which is the usual failure point on cheap bench cleaners.
• Rear main switch: A separate switch at the back isolates the machine from the mains after use, cutting standby consumption and giving a second layer of protection during maintenance.
• Efficient drive circuit: A revised conversion circuit raises electrical efficiency, so the same cleaning result is reached with a shorter cycle and less heat inside the enclosure.

The T2 fits repair benches and small workshops that clean in ones and twos. Optical and camera technicians clean ferrules, filter rings, small lens mounts and adapters; jewellers and watchmakers clean settings, bracelets and case parts after polishing; dental and beauty practices clean burs, tips and small instruments. Electronics benches use it for connectors, heat sinks and board sections before rework, and workshops clean carburettor jets, injector nozzles and small pneumatic fittings. Laboratories use the two litre bath for sample tubes, sieves and small glassware where a larger tank would waste detergent.

The T series is covered by CE verification (T188066801 and T188066802), RoHS compliance (T188066803), FCC verification (T188103901 and T188103902) and REACH compliance (T188085501). Report copies are supplied with the shipping documents for customs clearance, tender submission and distributor registration, and the design is patent protected, so a repeat order matches the tested sample rather than drifting between production runs.

Each machine packs in a foam lined gift box with basket, lid, power cord and manual, then into a master carton for air or sea shipment. Every unit runs a two hour load test, a heater ramp check, a leak test on the tank and a knob response check before packing, and the serial number is recorded on the inspection sheet. The one year warranty covers the generator board, transducers and heater, with spare baskets and knobs held in stock.

Send us the parts you need to clean and the solution volume you prefer, and we will confirm the two litre tank or recommend the T3 for longer items.